The
Scarecrow is made of paper Mache, Hot Glue, and Sprayfoam Insulation. Three Layers of Paint was added to give the final look.
Parts List
ACC Skeleton - Upper Torso with Skull used as mold only
Paper Towels 3 pack - $1.99
White Glue - $2.00
White Air Dry Clay - $5.00
Green Moss Craft paint - $1.00
Black Spray paint - $2.00
Sand Tones Tan Paint - $0.00 Free From Work
Misc PVC 12" of 1/2" Pipe - $0.40
Misc PVC 1/2" to 1/2" Connector - $0.30
Fall Decrative Leaves - $3.00
Hot Glue sticks - $3.00
4x4 Post - 1/2 Rotten and Found at work Free
Rope - Strands from Jute netting P/R - $0.25
8 Small Closed Eye Hooks - $2.00
4 Small Zip Ties P/R - $0.25
Small Art detailing Brush - $1.50
5 Min Quick Set Epoxy - $2.00
Spray Foam Insulation - $5.00
Spray Semi gloss polyurathane - $2.00
Total - $31.69
At the Joints of the arms and to the hands I put a total of 8 closed eye hooks and connected them with small zip ties so the arms would have the movement of normal arms and blow in the wind. The whole Scarecrow was molded and mached ontop of a ACC bucky Upper Torso when the Mache dried I pulled it off and reinforced the mache then I used spray foam Unsulation to fill in the open space. the chest cavity head and arms are filled with foam. The Teeth and hands were made with hot glue I made a inpression in white air drying clay let it dry 24 hours and filled the mold with hot glue.
Good Luck Everyone